Skip to content

AZ-Touch Feather~

The AZ-Touch Feather also uses a 2.8" TFT display but the footprint on the PCB is only suitable for the Adafruit Feather family of MCUs. This AZ-Touch Feather kit can also be used to run openHASP with the HUZZAH32 or SparkFun Thing Plus ESP32-WROOM development boards.

Unlike the AZ-Touch MOD, the AZ-Touch Feather is a self-solder kit! You have to solder all components to the PCB yourself. For this reason the AZ-Touch MOD is recommended over the AZ-Touch Feather.

Pros Cons
Versatile PCB options All components need soldering
Choice of several ESP32 MCUs Bulky enclosure
9 to 35V DC-DC power input Resistive touchpanel
Breadboard area

AZ-Touch Feather

Feather dev boards~

We do not offer pre-built binaries for the AZ-Touch Feather yet but these dev boards should work:

Board HUZZAH32 SparkFun Thing Plus
MCU ESP32-WROOM ESP32-WROOM
Flash 4 MB 16 MB
PSram No No
Buy Buy

Documentation~

Schematics   Datasheet   Assembly Guide

Backlight Control~

GPIO13 of the ESP32 is used for PWM dimming of the AZ-Touch Feather display.

Enclosure~

Each AZ-Touch kit comes with a nice wall mounting enclosure for the 2.4" or 2.8" touchscreen. It enables you to mount your project permanently in your living room, corridor or other exposed places.

The AZ-Touch Feather contains loose components that you need to solder to the PCB yourself using the Assembly Guide.

The wall mounted enclosure measures 120mm x 80mm x 35mm (W x H x D).

Flashing~

The ESP32 can be flashed over USB like any ESP32 development board.


Last update: 2024-03-27